Case Modding Questions
<div class="IPBDescription">Plexiglass woes</div> Currently in the middle of doing a rather simple case mod for myself. Just finished air-brushing a design on one side of the case, and I'm preparing to install a window mod on the other panel.
I plan on going about this 1 of 2 ways.
1.) Install rubber, window, then spray-paint logo onto plexiglass.
2.) Install rubber, window, then etch a design into plexiglass and light it up via LEDs
I'll prolly end up doing option 1 anyway...
So 2 questions.
1.) Does anyone know of a spray paint that will work well on plexiglass. IE Not run, and give a nice even finish
2.) Does anyone have a link to that article that explains how to light up a design in plexiglass. I recall it was posted ages ago, but I'll be damned if I can find it.
Once I get the whole thing done (HOPEFULLY, by the end of the week) I'll post some pictures of it. That is of course after I show it off at a LAN party this weekend~
It was worth every penny.
I plan on going about this 1 of 2 ways.
1.) Install rubber, window, then spray-paint logo onto plexiglass.
2.) Install rubber, window, then etch a design into plexiglass and light it up via LEDs
I'll prolly end up doing option 1 anyway...
So 2 questions.
1.) Does anyone know of a spray paint that will work well on plexiglass. IE Not run, and give a nice even finish
2.) Does anyone have a link to that article that explains how to light up a design in plexiglass. I recall it was posted ages ago, but I'll be damned if I can find it.
Once I get the whole thing done (HOPEFULLY, by the end of the week) I'll post some pictures of it. That is of course after I show it off at a LAN party this weekend~
It was worth every penny.